Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing and prevents outer ring rotation within the housing. Shaft lock is achieved by either set screw or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP™ grease loss and friction. Depending on your preference, these bearings are available in both inch and metric shaft sizes with a wide variety of cast iron, stamped steel or rubber mount housings, sealing and lubrication options or industry specific solutions as illustrated. Sealmaster® Pillow Block Ball Bearing, 1-Piece Standard Duty, Series: NP Series, 25 mm Bore Dia, 98.4 to 111.1 mm Bolt Center-to-Center Length, 36.5 mm Base to Bore Centerline, 139.7 mm Overall Length, 34.9 mm Overall Width, 71.4 mm Overall Height, Two-Bolt Base Mount, Straight Bore Type, 38.1 mm Base Width, Set Screw Locking Device, Nomex® Labyrinth Seal, Non-Expansion, 12459 N Dynamic, 400 °F, 2750 RPM Maximum, 52100 Steel, Black Oxide